![]() ![]() The maximum number of 90-degree bends shall not exceed four between junction boxes.īushings shall be provided where entering a box, fitting or enclosure unless the box or fitting is designed to afford equivalent protection.Įnds of raceways shall be reamed to remove rough edges. Securely fastened bushings or grommets shall be provided to protect wiring run through openings in metal framing members. Where installed in grooves, to be covered by wallboard, siding, paneling, carpeting, or similar finish, wiring methods shall be protected by 0.0625-inchthick steel plate, sleeve, or equivalent, a listed steel plate or by not less than 1 1/ 4-inch free space for the full length of the groove in which the cable or raceway is installed. Where run parallel with the framing member or furring strip, the wiring shall be not less than 1 1/ 4 inches from the edge of a furring strip or a framing member such as a joist, rafter or stud or shall be physically protected.īored holes in framing members for wiring shall be located not less than 1 1/ 4 inches from the edge of the framing member or shall be protected with a minimum 0.0625-inch steel plate or sleeve, a listed steel plate or other physical protection. TABLE E3802.1 GENERAL INSTALLATION AND SUPPORT REQUIREMENTS FOR WIRING METHODS a, b, c, d, e, f, g, h, i, j, k INSTALLATION REQUIREMENTS (Requirement applicable only to wiring methods marked "A" ) ![]() The insulated conductors under the metallic covering are listed for use in wet locations and a corrosion-resistant jacket is provided over the metallic sheath.A lead sheath or moisture-impervious jacket is provided under the metal covering.The metallic covering is impervious to moisture.In wet locations under any of the following conditions:.Liquid-tight flexible nonmetallic conduit is permitted to be encased in concrete where listed for direct burial and only straight connectors listed for use with LFNC are used.Conduit shall not exceed 6 feet in length.Shall be listed as "Sunlight Resistant" where exposed to the direct rays of the sun. ![]() Aluminum RMC requires approved supplementary corrosion protection.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |